Small Coal Tender (Schute_M2) Problem in GWX 2.1

Reece · 04-26-08, 12:47 AM

Previously I thought this to be a fault of the zones.cfg file but this has been fixed and on a completely new patrol & area came across this, engines running but stationary:

I was able to sink it but even after "NA she's going down" message the man is still there:

The Schute_M2.cfg file contains the following:

[Unit]
ClassName=Schute_M2
UnitType=104
MaxSpeed=9
Length=48
Width=9.8
Mast=11.3
Draft=2.2
Displacement=305
RenownAwarded=20

[2DCompartments]
UnitPos=137,12,237,16
NbOfComp=1
Name1=Keel
Area1=203,5,93,11

Is there any problem, seems the ships waterline is way too high, any suggestions?

I tried to load the Museum but gets to about 1/4 way with red bar & CTD, all mods have been disabled, I did forget to roll back SH3 Commander, doubt this would cause problems!

Any ideas?

Thanks.

04-26-08, 12:47 AM	#1
Reece CINC Pacific Fleet Join Date: Sep 2003 Location: Down Under Posts: 34,731 Downloads: 171 Uploads: 0	Small Coal Tender (Schute_M2) Problem in GWX 2.1 Previously I thought this to be a fault of the zones.cfg file but this has been fixed and on a completely new patrol & area came across this, engines running but stationary: I was able to sink it but even after "NA she's going down" message the man is still there: The Schute_M2.cfg file contains the following: [Unit] ClassName=Schute_M2 UnitType=104 MaxSpeed=9 Length=48 Width=9.8 Mast=11.3 Draft=2.2 Displacement=305 RenownAwarded=20 [2DCompartments] UnitPos=137,12,237,16 NbOfComp=1 Name1=Keel Area1=203,5,93,11 Is there any problem, seems the ships waterline is way too high, any suggestions? I tried to load the Museum but gets to about 1/4 way with red bar & CTD, all mods have been disabled, I did forget to roll back SH3 Commander, doubt this would cause problems! Any ideas? Thanks. __________________ *Sub captains go down with their ship!* Last edited by Reece; 04-26-08 at 01:22 AM.