Crash when loading savegame

laminator · 04-18-07, 07:56 PM

Hi mates!

I have the problem that the game ALLWAYS crashes when i try to load a savegame. As i have not the time needed to finish each patrol in a single session, this prevents me from progressing further in the carrier-path. And as the carrier is the most promising part of the game this situation is very disturbing.

Autosaves (when leaving port) work correct.

Gameversion is 1.2, no mods installed.
System is p4 dual 3ghz, 1gb ram, Gforce 6600 256mb, drivers are latest versions.

Any hints?

regards
laminator

SteamWake · 04-18-07, 07:58 PM

Were they save games previous to patching to 1.2 ?

If so non sympatico..

laminator · 04-18-07, 08:37 PM

no, after installing the new patch i started a new carrer as i read that old savegames amidst a patrol won´t load.

i really enjoy subsims very much, even if sh4 has some quirks right now, but without a working career it will be pretty boring for my taste

regards
laminator

laminator · 04-18-07, 08:40 PM

i read in a different thread that installing 1.2 over 1.1 can cause problems. any confirmation avail?

in the patch-thread is stated that it is a patch working on ALL prior versions...

nfitzsimmons · 04-18-07, 08:42 PM

Quote:

Originally Posted by laminator

i read in a different thread that installing 1.2 over 1.1 can cause problems. any confirmation avail?

in the patch-thread is stated that it is a patch working on ALL prior versions...

I did a clean install, installed 1.1 patch, then 1.2 patch. No problems or crashes so far. No problems loading saved games.

On the other hand I haven't re-installed any mods yet, either. Waiting till I finish this patrol.

walsh2509 · 04-18-07, 09:35 PM

Check your Graphics card for anti whatever you call it and Vsync, I had anti-A set and 2x and same with the other at 2x, up close the lines and wires on ships looked good but at a distance it was still a case of broken or missing lines and wires. So I up'd the Anti-A to x8 and same with the other one.

I ran the game and when the intro stopped the game just went back to DT, could not figure it out, when I put Anti-a back to 2x and the other one the same, I got passed the intros and the game loaded. So when the logo and intro vid were done I was crashing to DT but when I put the anti-a and back no more CDT..

laminator · 04-20-07, 07:31 PM

As i found no solution for my problem I went for a full reinstall and direct patch to 1.2. Now anything works as expected

Thanks mates for your assistance, but now I have to leave, my crew is in desperate need of their captain

regards
laminator

04-18-07, 07:56 PM	#1
laminator Swabbie Join Date: Apr 2007 Posts: 7 Downloads: 105 Uploads: 0	Crash when loading savegame Hi mates! I have the problem that the game ALLWAYS crashes when i try to load a savegame. As i have not the time needed to finish each patrol in a single session, this prevents me from progressing further in the carrier-path. And as the carrier is the most promising part of the game this situation is very disturbing. Autosaves (when leaving port) work correct. Gameversion is 1.2, no mods installed. System is p4 dual 3ghz, 1gb ram, Gforce 6600 256mb, drivers are latest versions. Any hints? regards laminator

04-18-07, 07:58 PM	#2
SteamWake Rear Admiral Join Date: Mar 2005 Posts: 13,224 Downloads: 5 Uploads: 0	Were they save games previous to patching to 1.2 ? If so non sympatico..

04-18-07, 08:37 PM	#3
laminator Swabbie Join Date: Apr 2007 Posts: 7 Downloads: 105 Uploads: 0	no, after installing the new patch i started a new carrer as i read that old savegames amidst a patrol won´t load. i really enjoy subsims very much, even if sh4 has some quirks right now, but without a working career it will be pretty boring for my taste regards laminator

04-18-07, 08:40 PM	#4
laminator Swabbie Join Date: Apr 2007 Posts: 7 Downloads: 105 Uploads: 0	i read in a different thread that installing 1.2 over 1.1 can cause problems. any confirmation avail? in the patch-thread is stated that it is a patch working on ALL prior versions...

04-18-07, 09:35 PM	#6
walsh2509 XO Join Date: Apr 2005 Posts: 410 Downloads: 18 Uploads: 0	Check your Graphics card for anti whatever you call it and Vsync, I had anti-A set and 2x and same with the other at 2x, up close the lines and wires on ships looked good but at a distance it was still a case of broken or missing lines and wires. So I up'd the Anti-A to x8 and same with the other one. I ran the game and when the intro stopped the game just went back to DT, could not figure it out, when I put Anti-a back to 2x and the other one the same, I got passed the intros and the game loaded. So when the logo and intro vid were done I was crashing to DT but when I put the anti-a and back no more CDT..

04-20-07, 07:31 PM	#7
laminator Swabbie Join Date: Apr 2007 Posts: 7 Downloads: 105 Uploads: 0	As i found no solution for my problem I went for a full reinstall and direct patch to 1.2. Now anything works as expected Thanks mates for your assistance, but now I have to leave, my crew is in desperate need of their captain regards laminator