SUBSIM Radio Room Forums

SUBSIM Radio Room Forums (https://www.subsim.com/radioroom/index.php)
-   Silent Hunter 4: Wolves of the Pacific (https://www.subsim.com/radioroom/forumdisplay.php?f=202)
-   -   Crash when loading savegame (https://www.subsim.com/radioroom/showthread.php?t=112430)

laminator 04-18-07 07:56 PM

Crash when loading savegame
 
Hi mates!

I have the problem that the game ALLWAYS crashes when i try to load a savegame. As i have not the time needed to finish each patrol in a single session, this prevents me from progressing further in the carrier-path. And as the carrier is the most promising part of the game this situation is very disturbing.

Autosaves (when leaving port) work correct.

Gameversion is 1.2, no mods installed.
System is p4 dual 3ghz, 1gb ram, Gforce 6600 256mb, drivers are latest versions.

Any hints?

regards
laminator

SteamWake 04-18-07 07:58 PM

Were they save games previous to patching to 1.2 ?

If so non sympatico.. ;)

laminator 04-18-07 08:37 PM

no, after installing the new patch i started a new carrer as i read that old savegames amidst a patrol won´t load.

i really enjoy subsims very much, even if sh4 has some quirks right now, but without a working career it will be pretty boring for my taste:(

regards
laminator

laminator 04-18-07 08:40 PM

i read in a different thread that installing 1.2 over 1.1 can cause problems. any confirmation avail?

in the patch-thread is stated that it is a patch working on ALL prior versions...

nfitzsimmons 04-18-07 08:42 PM

Quote:

Originally Posted by laminator
i read in a different thread that installing 1.2 over 1.1 can cause problems. any confirmation avail?

in the patch-thread is stated that it is a patch working on ALL prior versions...

I did a clean install, installed 1.1 patch, then 1.2 patch. No problems or crashes so far. No problems loading saved games.

On the other hand I haven't re-installed any mods yet, either. Waiting till I finish this patrol.

walsh2509 04-18-07 09:35 PM

Check your Graphics card for anti whatever you call it and Vsync, I had anti-A set and 2x and same with the other at 2x, up close the lines and wires on ships looked good but at a distance it was still a case of broken or missing lines and wires. So I up'd the Anti-A to x8 and same with the other one.

I ran the game and when the intro stopped the game just went back to DT, could not figure it out, when I put Anti-a back to 2x and the other one the same, I got passed the intros and the game loaded. So when the logo and intro vid were done I was crashing to DT but when I put the anti-a and back no more CDT..

laminator 04-20-07 07:31 PM

As i found no solution for my problem I went for a full reinstall and direct patch to 1.2. Now anything works as expected:)

Thanks mates for your assistance, but now I have to leave, my crew is in desperate need of their captain;)

regards
laminator


All times are GMT -5. The time now is 11:24 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1995- 2025 Subsim®
"Subsim" is a registered trademark, all rights reserved.