Crash when loading savegame

nfitzsimmons · 04-18-07, 08:42 PM

Quote:

Originally Posted by laminator

i read in a different thread that installing 1.2 over 1.1 can cause problems. any confirmation avail?

in the patch-thread is stated that it is a patch working on ALL prior versions...

I did a clean install, installed 1.1 patch, then 1.2 patch. No problems or crashes so far. No problems loading saved games.

On the other hand I haven't re-installed any mods yet, either. Waiting till I finish this patrol.

walsh2509 · 04-18-07, 09:35 PM

Check your Graphics card for anti whatever you call it and Vsync, I had anti-A set and 2x and same with the other at 2x, up close the lines and wires on ships looked good but at a distance it was still a case of broken or missing lines and wires. So I up'd the Anti-A to x8 and same with the other one.

I ran the game and when the intro stopped the game just went back to DT, could not figure it out, when I put Anti-a back to 2x and the other one the same, I got passed the intros and the game loaded. So when the logo and intro vid were done I was crashing to DT but when I put the anti-a and back no more CDT..

laminator · 04-20-07, 07:31 PM

As i found no solution for my problem I went for a full reinstall and direct patch to 1.2. Now anything works as expected

Thanks mates for your assistance, but now I have to leave, my crew is in desperate need of their captain

regards
laminator

04-18-07, 09:35 PM	#2
walsh2509 XO Join Date: Apr 2005 Posts: 410 Downloads: 18 Uploads: 0	Check your Graphics card for anti whatever you call it and Vsync, I had anti-A set and 2x and same with the other at 2x, up close the lines and wires on ships looked good but at a distance it was still a case of broken or missing lines and wires. So I up'd the Anti-A to x8 and same with the other one. I ran the game and when the intro stopped the game just went back to DT, could not figure it out, when I put Anti-a back to 2x and the other one the same, I got passed the intros and the game loaded. So when the logo and intro vid were done I was crashing to DT but when I put the anti-a and back no more CDT..

04-20-07, 07:31 PM	#3
laminator Swabbie Join Date: Apr 2007 Posts: 7 Downloads: 105 Uploads: 0	As i found no solution for my problem I went for a full reinstall and direct patch to 1.2. Now anything works as expected Thanks mates for your assistance, but now I have to leave, my crew is in desperate need of their captain regards laminator