This is embarassing

Tonci87 · 05-12-19, 06:30 AM

Well the trick is simple really, just don´t draw two lines from the exact same position

No seriously, if you look closely, you will notice that I do not actually start to draw the line from the exact position where the first line starts, since then the tool would only "pick up" the first line again. I always go a few pixels to the side.
You can see that very well at 5:20.

Another trick, if you absolutely have to draw the line from a marker point for example, is to drag out the original line a bit behind the mark (so that it goes through the mark), and then start the new line from the marker again.

I hope that helps

05-12-19, 06:30 AM	#8
Tonci87 Samurai Navy Join Date: Jun 2012 Posts: 573 Downloads: 119 Uploads: 0	Well the trick is simple really, just don´t draw two lines from the exact same position No seriously, if you look closely, you will notice that I do not actually start to draw the line from the exact position where the first line starts, since then the tool would only "pick up" the first line again. I always go a few pixels to the side. You can see that very well at 5:20. Another trick, if you absolutely have to draw the line from a marker point for example, is to drag out the original line a bit behind the mark (so that it goes through the mark), and then start the new line from the marker again. I hope that helps __________________ How to use the RAOBF to measure speed, range and AOB, and then use the Attack Disc to set up a perfect 90° attack. Your diveplane controllers are killing you! Das Brot https://www.youtube.com/watch?v=Irs1NOMJVfg