Tonnage war

[THEBERBSTER]

Hi Sandman
You do not state the port you are leaving or which campaign you are in.
Is there a Harbor Pliot listed for the port you are in?
Did you exit to the desk top before starting your new mission?
Peter

[Sandman_28054]

Originally Posted by THEBERBSTER

Hi Sandman
You do not state the port you are leaving or which campaign you are in.

La Pallice (?)

Is there a Harbor Pliot listed for the port you are in?

yes

Did you exit to the desk top before starting your new mission?
Peter

Yes

As of right now, all I can do is hit the (~) to "All Stop" and stop the Harbor Pilot. Then switch to the right one.

[THEBERBSTER]

Hi Sandman
I have had the harbor pilot ram me into the dock and also into the coastal boats that patrol the harbor on occassions.
I have not touched anything to make this happen.
Peter

[Sandman_28054]

Originally Posted by THEBERBSTER

Hi Sandman
I have had the harbor pilot ram me into the dock and also into the coastal boats that patrol the harbor on occassions.
I have not touched anything to make this happen.
Peter

I don't know what to tell you.

Just put in to La Pallice, resupplied, no mission as I have already met the requirments. Saved the game. Exited.

I bet you a shinny new penny when I start the game up, the harbor pilot will still be set for Brest.

[Trevally.]

Hi Sandman

The correct pilot must be selected by the users at the dock.
If "Brest" is selected, click stop and clear it. Then choose the correct one.

A pilot may be stuck in memory if it was used and not allowed to finish. So when leaving port, let it run to the end. If you want it to end manually, stop it and ensure it has cleared out of the automation window.

TDW added a waypoint resume where you can take over from the pilot (iceberg ahead or that dam coastal boat), the pilot can then resume after you have taken action.
It could be that this is causing your constant Brest issue

[Sandman_28054]

Originally Posted by Trevally.

Hi Sandman

The correct pilot must be selected by the users at the dock.
If "Brest" is selected, click stop and clear it. Then choose the correct one.

Do that every mission.

A pilot may be stuck in memory if it was used and not allowed to finish. So when leaving port, let it run to the end. If you want it to end manually, stop it and ensure it has cleared out of the automation window.

I do that too.

TDW added a waypoint resume where you can take over from the pilot (iceberg ahead or that dam coastal boat), the pilot can then resume after you have taken action.
It could be that this is causing your constant Brest issue

Only time thay has happened is when a ship gets too close.

Like I said, i was just wondering.