![]() |
SUBSIM: The Web's #1 resource for all submarine & naval simulations since 1997 |
![]() |
#1 |
Chief
![]() Join Date: Aug 2019
Location: Patroling the south pacific
Posts: 321
Downloads: 75
Uploads: 0
|
![]()
Are the numbers a percent?
3 digits. If not a percent, what do they represent and what should I be concerned over? |
![]() |
![]() |
![]() |
#2 |
Ocean Warrior
![]() Join Date: Feb 2010
Location: Kentucky
Posts: 2,528
Downloads: 77
Uploads: 0
|
![]()
I've seen a couple explanations. One is an actual percent. 100% means the hull is completely damaged. Critical damage happens somewhere at a lower percentage. The other explanation is it's percentage of damage leading up to sinking. 50% damage means the hull is half way to collapsing. 100% means the hull is collapsing. Of course, with either one, with a weakened hull, if the boat goes too deep, the hull will take more damage.
__________________
Of all the forms of Martial Arts, Karaoke causes the most pain! |
![]() |
![]() |
![]() |
#3 | |
Silent Hunter
![]() |
![]() Quote:
![]() and before you ask, no, there is no abandon ship command. ![]() ![]()
__________________
there are only two things in the world: submarines and targets. Fortis et stabilis et fidelis, semper ![]() ![]() ![]() ------------------------------------------------------------ Silent Hunter 4 1.5 Gold Edition on CDROM LAA enabled Dell XPS with 32 GB Ram running Win10 |
|
![]() |
![]() |
![]() |
#4 |
CTD - it's not just a job
|
![]()
Actually, I think you start to tip the scale to the point of no return at 40%. If you hit that, you will eventually sink. Of course, there are ways to get below 40% all too easily...
![]() ![]() ![]()
__________________
"...and bollocks to the naysayers" - Jimbuna |
![]() |
![]() |
![]() |
#5 |
Sonar Guy
![]() |
![]()
I've made port after 55% damage, but that was done on the surface, not at depth. I've never recovered from above 40% damage at depth, though it's very rare but catastrophic to take even a small hit well below the test depth, my preferred post-attack profile.
|
![]() |
![]() |
![]() |
|
|