|
|
SUBSIM: The Web's #1 resource for all submarine & naval simulations since 1997
|
SUBSIM: The Web's #1 resource for all submarine & naval simulations since 1997 |
05-09-10, 07:56 PM
|
#1 |
|
A-ganger
 Join Date: Jul 2008
Location: Patroling somewhere in Your toilet...it smells rather bad...
Posts: 74
Downloads: 48
Uploads: 2
|
[TEC] Can you model with Solidworks
Well long story short, my computer had to get some repairs done, and when my HDD was wiped, I lost my copy of 3ds Max(this is as far as I go.) But I did get a copy of Solidworks from a friend. I was wondering if I would beable to do the models on there?
Its a type inwhich you draw out the piece, then send it over to an assembly, and put it all together... but would this work for this type of work? Thanks -Gun
__________________
"When the pin is pulled, Mr. Grenade is not our friend." -U.S. Army Training Notice |
|
|
|
|
Threaded Mode