![]() |
SUBSIM: The Web's #1 resource for all submarine & naval simulations since 1997 |
![]() |
#1 |
Watch
![]() Join Date: Jun 2009
Posts: 28
Downloads: 4
Uploads: 0
|
![]()
I'm just wondering if destroyers can hear your rudder and dive planes if you change course/depth while running silent. Basically what I want to know is if I should move my rudder sparingly or not at all when I'm not being depth charged?
|
![]() |
![]() |
![]() |
#2 |
Chief of the Boat
|
![]()
I don't think it's actually a case of hearing your rudder etc. but more a case of the game engine simply 'hearing' your boat as an entity.
Always try to keep as narrow a profile as possible pointing at the escort and keep your rpm below 100. |
![]() |
![]() |
![]() |
#3 |
Subsim Aviator
|
![]()
destroyers have four modes of detection
1. visual - the DD crew observes your surfaced u-boat, or a part of your u-boat as it penetrates the surface 2. Radar - they detect your radar signals or your radar signature of your surfaced boat. 3. Passive Sonar - they hear your engines running / props turning or repair work being conducted / torpedoes being loaded (if not silent running) they dont hear anything else. (motors, dive planes, rudders etc) 4. Active Sonar - sound signal hits your boat and reflects a target... this depends heavily on your aspect ratio and depth
__________________
![]() |
![]() |
![]() |
![]() |
#4 |
Mate
![]() Join Date: May 2009
Posts: 57
Downloads: 94
Uploads: 0
|
![]()
How do you keep your engine under a specific RPM? Usually I just go 1-2 knots at silent running. Is there a different way to set your RPM versus a speed?
|
![]() |
![]() |
![]() |
#5 |
Subsim Aviator
|
![]()
next to the engine order telegraph dial on the user interface there is a little round button.
click the button and the telegraph dial turns into a knot meter indicating the current speed. if you click somewhere between 1 and 2 knots, the speed of the engines will reduce to lower RPM. you can see your engine tachometers on the tach gauges directly over the planesmen in the command room view. the needle should point to about 50 RPM of course the trade off is that you are barely outrunning most garden snails... let alone hedge hogs and depth charges.
__________________
![]() |
![]() |
![]() |
![]() |
#6 | |
Grey Wolf
![]() Join Date: Jul 2007
Location: LI NY
Posts: 964
Downloads: 13
Uploads: 0
|
Quote:
![]()
__________________
![]() "Only if I can save first..." |
|
![]() |
![]() |
![]() |
#7 |
Engineer
![]() Join Date: Jun 2007
Location: 2074 nautical miles south west of San Francisco!
Posts: 212
Downloads: 71
Uploads: 0
|
![]()
Well its obvious that they can hear your screws turning at a certain speed. Try crusin @ 2 knots infront of a DD with no reaction..then hit the throttle and watch the bad guys cr@p on you like a flock of seagulls at lunch time.
__________________
GWX3GOLD OLC "Gold" MkIId SH3 Commander D.I.D 100% Realism ! SWCs-AtlanticReaper Skin <---because it is badass! ![]() |
![]() |
![]() |
![]() |
#8 | |
Chief of the Boat
|
![]() Quote:
![]() As GR stated in the first part of the above ![]() |
|
![]() |
![]() |
![]() |
#9 |
Eternal Patrol
![]() |
![]()
No, they can't hear your rudder and dive planes.
__________________
“Never do anything you can't take back.” —Rocky Russo |
![]() |
![]() |
![]() |
|
|