SH3 no longer recognizes enemy!

AtlantikEel · 04-17-08, 11:33 PM

For each of my last two careers in GWX2.0, every vessel sunk was listed as neutral on exiting the game, even when every vessel sunk carried a British flag. Prior to this, all was fine.

Tonight I uninstalled the entire game, and deleted all folders, mods, and SH3commander 2.7, in preparation for install of GWX2.1 and SH3Commander 3.

After re-installing SH3 and 1.4b, I ran the Barlow mission, just to satisfy myself that the game was operating properly before further install.
I sank the Barlow, exited the game, and found the the sinking again listed as a neutral vessel!
So the fault could not have been with GWX2.0 (which as I say, ran fine previously). For whatever reason, SH3 will no longer recognize vessels as enemy on my computer.

Any help that anyone can provide toward resolving this problem will be greatly appreciated.

04-17-08, 11:33 PM	#1
AtlantikEel A-ganger Join Date: Jun 2007 Location: Edmonton, Alberta, Canada Posts: 74 Downloads: 0 Uploads: 0	SH3 no longer recognizes enemy! For each of my last two careers in GWX2.0, every vessel sunk was listed as neutral on exiting the game, even when every vessel sunk carried a British flag. Prior to this, all was fine. Tonight I uninstalled the entire game, and deleted all folders, mods, and SH3commander 2.7, in preparation for install of GWX2.1 and SH3Commander 3. After re-installing SH3 and 1.4b, I ran the Barlow mission, just to satisfy myself that the game was operating properly before further install. I sank the Barlow, exited the game, and found the the sinking again listed as a neutral vessel! So the fault could not have been with GWX2.0 (which as I say, ran fine previously). For whatever reason, SH3 will no longer recognize vessels as enemy on my computer. Any help that anyone can provide toward resolving this problem will be greatly appreciated.