Am I cheating?

kkentopanga · 02-13-07, 08:53 PM

I have became very good at using the targeting/plotting tools in the TDC to sink single ships with only using my periscope once. Once I get a bearing and speed I lower scope and go to my TDC where I imput the bearing as 0 and the AOB as 0, I then watch my moving chart and make adjustments in angle and speed and range till the ship will cross my bow at 90 at any where from 400M to 1000M. The ships show up as ships on the moving plotter and your boot has a line to midship on the target. Once I fire I go to my scope and 90% of the time I see the torp wake heading right where I amed it. It will not work on convoys, too many targets, or warships (to da_ fasdt. If this is a cheat I will quit doing it.

02-13-07, 08:53 PM	#1
kkentopanga Helmsman Join Date: Oct 2006 Location: Roseville CA Posts: 102 Downloads: 0 Uploads: 0	Am I cheating? I have became very good at using the targeting/plotting tools in the TDC to sink single ships with only using my periscope once. Once I get a bearing and speed I lower scope and go to my TDC where I imput the bearing as 0 and the AOB as 0, I then watch my moving chart and make adjustments in angle and speed and range till the ship will cross my bow at 90 at any where from 400M to 1000M. The ships show up as ships on the moving plotter and your boot has a line to midship on the target. Once I fire I go to my scope and 90% of the time I see the torp wake heading right where I amed it. It will not work on convoys, too many targets, or warships (to da_ fasdt. If this is a cheat I will quit doing it.