[REL]OpenHatch_V3_RH released

[WilhelmSchulz.]

Great work! But the hach on the IX one seams too small. You would have to crawl through that.

[Jager]

Very awesome mod I have it installed and it looks great!

[WilhelmSchulz.]

Hey DD, What happend to the other room?

[Captain Strangelove]

I don't want to believe that this thread has ended up on page 2 of the mods workshop! ?

DivingDuck, are there any news? Is it still reasonable to hope that some miracle will happen and we will have a third room? Or is it just not possible without an SDK?

Thanks!

Kai

[DivingDuck]

Hi CSL,

there´s room for hope. This mod isn´t dead yet. As I have several queries about the captains position on conning tower I´m a little sidetracked at the moment. Didn´t use the MiniTweaker till now. But I´m thinking about writing a tweakfile for this issue. (http://www.subsim.com/radioroom/show...558#post487558) If I succeed, these files will be provided together with OH. But before I start another approach at the next compartment I have to dig deep to get the obs periscope moving up and down by key command.


Regards,
DD


PS: From time to time I have to fresh up my mind modding one or another little thing that doesn´t directly belong to u-boat interior.

[DivingDuck]

Moin,

as announced above I´ve written some tweak files to change the captain´s viewpoint position. You may download them here.

The following towers are included:

• Turm2A_1_hd
• Turm2D_1_hd
• Turm2D_2_hd
• Turm7b_1_hd
• Turm7b_2_hd
• Turm7b_3_hd
• Turm7b_4_hd
• Turm9c_1_hd
• Turm9c_2_hd
• Turm9c_3_hd

Download, extract and copy to ...MiniTweaker\Tweakfiles. Launch MiniTweaker an load the file needed. UseInitialLocalPos must be set to "1" to make SHIII use your values.

Regards,
DD

[Reece]

Thanks DD, it obviously turned out to be a little harder than you first thought, did you PM Shepelly about this good news?

[P_Funk]

I downloaded DD_TypeVII_OH_Peri_Correct.rar and I got this message when I went to unzip.

! F:\XXXXXXX\GWX full\open interior hatch\DD_TypeVII_OH_Peri_Correct.rar: CRC failed in TypeVII_OH_Peri_Correct\data\interior\NSS_Uboat7\N SS_Uboat7_CR.dat. The file is corrupt

[nfitzsimmons]

Originally Posted by P_Funk

I downloaded DD_TypeVII_OH_Peri_Correct.rar and I got this message when I went to unzip.

Maybe a bad download; mine worked fine.

[DivingDuck]

@P_Funk:

thanks for the info. Just test downloaded it and had the same error message. Seems as if reorganization of my FileFront folders structure ended up with this problem. Hope that´s the only file concerned.

Check back in 15min, I´ll upload it again.

Regards,
DD

[P_Funk]

All seems to be working fine now.

Much obliged.

[DivingDuck]

Same version, new file uploaded. I´ve test d´ld it and it worked fine.

Regards,
DD

[CaptainAsh]

great mode!

[P_Funk]

Just dlaoded the IX Open Hatch 1.01. Does this version make all the interior lights brighter than in 1.0? I noticed that the hair on my Navigator was shining like he'd been using too much Pomade.

[DivingDuck]

Moin,

Originally Posted by P_Funk

Just dlaoded the IX Open Hatch 1.01. Does this version make all the interior lights brighter than in 1.0? I noticed that the hair on my Navigator was shining like he'd been using too much Pomade.

LOL, no it doesn´t. V1.0 was lacking of the 0KB file (NSS_Uboat9_RR.dat) that is necessary for JSGME to install properly. Allthough V1.0 was working, some guys encountered visual problems when in the radio room, as the old one interferred with the new command room.
About the lights; I was told they are to shiny. Didn´t take a look at them, till now. But it´s on my ToDo-list.

Regards,
DD