Maybe a stupid question re: GWX 2.1 and SH3 Commander, but...

[Reckall]

OK, I installed everything for a nice GWX 2.1 experience except for the SH3 Commander files. At this point I stumbled into... not exactly an obstacle, but a doubt.

I have the GWX 2.1 config files for SH3 Commander (GWX_21.1_Cfg_4_SH3Cmdr3.0.7z). The instructions say that you have to unzip the content into the /cfg directory of SH3 Commander, which sounds clear enough.

However, by unzipping the files I see three directories in the .7z archive: /cfg /flotilla and /uboat - which are directories in my SH3 Commander installation too.

My question: should I overwrite the "fresh" SH3 Commander directories with those in the GWX 2.1 archive, or everything in the archive must go into the /cfg directory of SH3 Commander (thus creating /cfg /flotilla and /uboat subdirectories in the /cfg directory of SH3 Commander)?

Maybe I'm being too scrupolous, but I would hate to mess up my GWX 2.1 installation right on the last step!

Thanks for ther help!

Vince