How do you Point and Shoot?

heartc · 04-30-07, 01:52 PM

Well, the manual says when you hit "X" on the notepad (upper right hand dial system), the TDC system and all data will be reset, and target speed set to zero, which will result in the gyro angles being connected to the scope bearing, transforming it into a "point and shoot" device. You might want to check the Position Keeper to be inactive for this to work, though. I'm not sure about this whole thing as I never tried it yet. But according to the manual, this is the way it should work.

04-30-07, 01:52 PM	#1
heartc Samurai Navy Join Date: Dec 2006 Location: Munich Posts: 562 Downloads: 71 Uploads: 0	Well, the manual says when you hit "X" on the notepad (upper right hand dial system), the TDC system and all data will be reset, and target speed set to zero, which will result in the gyro angles being connected to the scope bearing, transforming it into a "point and shoot" device. You might want to check the Position Keeper to be inactive for this to work, though. I'm not sure about this whole thing as I never tried it yet. But according to the manual, this is the way it should work.