whats wrong with this picture!

Letum · 03-06-07, 08:20 PM

I don't know.

Useing the notepad is a poor way to get good manual TDC results anyway.

See:
http://www.paulwasserman.net/SHIII/

cowboys98 · 03-07-07, 12:41 AM

IM USING THE TDC MANUAL THIS IS WHAT IT SAYS:

Bring up your Ship Registry and look for your contact. Once found,
make sure to check the box so the mast height is entered on the notepad as in
the picture below. OK THIS IS WHAT AM TAKING ABOUT,WHEN I TRY TO DO THIS IM NOT GETTING MAST HEIGHT IN THE UPPER RIGHT CORNER WHERE IT SHOULD BE AS ILLUSTRADED IN THE FOTO

YOU SEE THAT IT SHOWS THE MAST HEIGHT,WELL I DONT HAVE THAT,WHEN I CLICK ON THE LITTLE BOX IN THE RECONITION MANUAL.

Get Range to Target

Place the horizontal line of your scope on the waterline of the target.
Next, click on “Range” in the Notepad. This will switch you to the Stadimeter
which you then place at the top of the highest mast of the ship.
Click the left mouse button when the line has been placed on the highest mast.
The range to target will then appear in the Notepad.

HERE IN THE TEXT IT SAYS CLICK ON RANGE IN THE NOTEPAD,WELL I DONT HAVE THAT SHOWING?
Get Range to Target

Place the horizontal line of your scope on the waterline of the target.
Next, click on “Range” in the Notepad. This will switch you to the Stadimeter
which you then place at the top of the highest mast of the ship.
Click the left mouse button when the line has been placed on the highest mast.
The range to target will then appear in the Notepad.

03-06-07, 08:20 PM	#1
Letum Navy Seal Join Date: Feb 2005 Location: York - UK Posts: 6,079 Downloads: 43 Uploads: 0	I don't know. Useing the notepad is a poor way to get good manual TDC results anyway. See: http://www.paulwasserman.net/SHIII/ __________________

03-07-07, 12:41 AM	#2
cowboys98 Mate Join Date: May 2005 Location: temple,texas Posts: 60 Downloads: 108 Uploads: 0	IM USING THE TDC MANUAL THIS IS WHAT IT SAYS: Bring up your Ship Registry and look for your contact. Once found, make sure to check the box so the mast height is entered on the notepad as in the picture below. OK THIS IS WHAT AM TAKING ABOUT,WHEN I TRY TO DO THIS IM NOT GETTING MAST HEIGHT IN THE UPPER RIGHT CORNER WHERE IT SHOULD BE AS ILLUSTRADED IN THE FOTO YOU SEE THAT IT SHOWS THE MAST HEIGHT,WELL I DONT HAVE THAT,WHEN I CLICK ON THE LITTLE BOX IN THE RECONITION MANUAL. Get Range to Target Place the horizontal line of your scope on the waterline of the target. Next, click on “Range” in the Notepad. This will switch you to the Stadimeter which you then place at the top of the highest mast of the ship. Click the left mouse button when the line has been placed on the highest mast. The range to target will then appear in the Notepad. HERE IN THE TEXT IT SAYS CLICK ON RANGE IN THE NOTEPAD,WELL I DONT HAVE THAT SHOWING? Get Range to Target Place the horizontal line of your scope on the waterline of the target. Next, click on “Range” in the Notepad. This will switch you to the Stadimeter which you then place at the top of the highest mast of the ship. Click the left mouse button when the line has been placed on the highest mast. The range to target will then appear in the Notepad.