Freezing issue...

[U-Bones]

Originally Posted by Jonte

Well I got "driver cleaner pro" and cleaned my new nvidia drivers out. I then tested them again with the same problem. I cleaned them out AGAIN and installed nvidias 78.01 drivers and the game runs stable! I think nvidias new drivers stink...

By the way I have a framerate between 10-20, is than normal? Can I increase it?

Thanks for all input!

This is not too bad for a Ti4600. You can increase it some by reducing the particle setting in the game options. I always ended up running older drivers on both my 4600 and my 5600, (but not the 6600) so I understand your position on newer drivers.

[Jonte]

I had already lowered particles down to 20 which made the gameplay smoother. I now lowered the particles down to 10 and 5 which made the game unstable again!? It seems that when I get the gameplay as smooth as I want it, it gets unstable and freezes...

Should I uncheck the high quality textures?

Also explosion particles don't seem connected to the particle setting, just smoke and waterspray? This make my game suck in the single mission Bismarck!

Any suggestions?:hmm:

[U-Bones]

Originally Posted by Jonte

I had already lowered particles down to 20 which made the gameplay smoother. I now lowered the particles down to 10 and 5 which made the game unstable again!? It seems that when I get the gameplay as smooth as I want it, it gets unstable and freezes...

Should I uncheck the high quality textures?

Also explosion particles don't seem connected to the particle setting, just smoke and waterspray? This make my game suck in the single mission Bismarck!

Any suggestions?:hmm:

Put it at whatever setting works best I would set it as high as it will comfortably run. Good luck with it.