SUBSIM Radio Room Forums



SUBSIM: The Web's #1 resource for all submarine & naval simulations since 1997

Go Back   SUBSIM Radio Room Forums > Silent Hunter 3 - 4 - 5 > SHIII Mods Workshop
Forget password? Reset here

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 07-26-16, 04:29 PM   #10
Wise
Engineer
 
Join Date: Jun 2012
Location: St.-Petersburg
Posts: 217
Downloads: 5
Uploads: 0
Default

Hmm... I understand.
I think, nothing will turn out.
In the file of the hull of the U-boat (Submarine/NSS_Uboatxx/NSS_Uboatxx.dat), in the main node there has to be a 3D model. In your new main node (Position) the 3D model is absent. Besides, 3d - center of model of the main node , is a water surface level point (waterline). Besides, dimensions of this model which are allocated above or below a waterline, also, have direct interrelation with a waterline. Possibly, they are "reference points" for the ACT and DLL files in which modeling of behavior of the boat on water is programmed (the surface position, emersion - immersion, draft, switching of engines from the diesel to electric motors and back, periscope depth, etc.)
In the Turms-files is allowed more free hierarchy of the nodes, because, Turms are children files from the hull . The main node of the Turm file is attached to a point of the node "Z01" of the hull, and not vice versa.
I regret, Manos.

Last edited by Wise; 07-26-16 at 10:56 PM.
Wise is offline   Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:49 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1995- 2025 Subsim®
"Subsim" is a registered trademark, all rights reserved.