Help with "3000 yard bearing tool"

BigWalleye · 02-08-13, 02:06 PM

You might want to try OTC 8.5:4.8 rather than 16:9. See if that let's you run full screen. That particular aspect ratio, IIRC, is intended to compensate for monitors which are advertized as 16:9 but actually edge-clip. BTW, quite a few (but not all) monitors allow you to turn off edge-clipping and run the full "advertized" screen aspect ratio. Sometimes it takes some plumbing around in the monitor set-up menus to find the setting to do this.

Oh yeah, and you did mention something about "the bearing tool" in one post. Are you also running the 3000-Yard (/Meter) Bearing Tool mod? Because it overwrites lots of files from both TMO and RSRDC.

02-08-13, 02:06 PM	#8
BigWalleye Sea Lord Join Date: Jul 2012 Location: On the Eye-lond, mon! Posts: 1,987 Downloads: 465 Uploads: 0	You might want to try OTC 8.5:4.8 rather than 16:9. See if that let's you run full screen. That particular aspect ratio, IIRC, is intended to compensate for monitors which are advertized as 16:9 but actually edge-clip. BTW, quite a few (but not all) monitors allow you to turn off edge-clipping and run the full "advertized" screen aspect ratio. Sometimes it takes some plumbing around in the monitor set-up menus to find the setting to do this. Oh yeah, and you did mention something about "the bearing tool" in one post. Are you also running the 3000-Yard (/Meter) Bearing Tool mod? Because it overwrites lots of files from both TMO and RSRDC.