Tube Selection

Nedlam · 08-17-12, 05:34 PM

Somewhere along the way I 'broke' the dial for my salvo selection dial, it's blank. I found the proper graphic file for it which I forgot to install up until now (in this case for a Type IXC) and now I have the markers indicating what tubes I'm selecting but they don't match the tubes that are actually selected?!?

I'm running the latest version of NYGM (3.6A I think) with AMC v1.1 gui. There's got to be a way to switch around the tubes because somewhere along the way I did it accidently.

Anyone know what the file is? I can't seem to find it. If it's hard coded then I can't begin to fathom what the heck I did to break it!

08-17-12, 05:34 PM	#1
Nedlam Ensign Join Date: Oct 2005 Posts: 222 Downloads: 48 Uploads: 0	Tube Selection Somewhere along the way I 'broke' the dial for my salvo selection dial, it's blank. I found the proper graphic file for it which I forgot to install up until now (in this case for a Type IXC) and now I have the markers indicating what tubes I'm selecting but they don't match the tubes that are actually selected?!? I'm running the latest version of NYGM (3.6A I think) with AMC v1.1 gui. There's got to be a way to switch around the tubes because somewhere along the way I did it accidently. Anyone know what the file is? I can't seem to find it. If it's hard coded then I can't begin to fathom what the heck I did to break it! __________________ You can never put too much water on a nuclear reactor...