RSRDC and OM

I'm goin' down · 05-21-11, 11:37 AM

My thinking cap is on. Lurk Lurk's instructions for OM do not say that you cannot run both the German and Amercian games from a single set up. If it does, I missed it. However, I can use multi SH4 to run a separate setup for each theater.

My next issue is that on the German side, using OM/OMEGU/Kiub, when I have identified a ship using to the onscreen identification button, the ID of the ship appears at the bottom of the screen. Then, if I open the ship's ID manual it will take me to the picture of the ship I have identified. That procedure does not seem to work when I am in a US sub in the PTO, and there are way too many ships to try to figure out which one I am observing. By the time I scan the target manual and select my target, it has sailed off. This applies to merchants particualary. Any ideas on this one? The manual does not seem to open automatically when using the button to try to ID the target. Nor do I see the ID of the target at the bottom of the screen.

05-21-11, 11:37 AM	#6
I'm goin' down Ocean Warrior Join Date: Sep 2008 Location: Notify command we have entered the Grass Sea Posts: 2,822 Downloads: 813 Uploads: 0	Back for more My thinking cap is on. Lurk Lurk's instructions for OM do not say that you cannot run both the German and Amercian games from a single set up. If it does, I missed it. However, I can use multi SH4 to run a separate setup for each theater. My next issue is that on the German side, using OM/OMEGU/Kiub, when I have identified a ship using to the onscreen identification button, the ID of the ship appears at the bottom of the screen. Then, if I open the ship's ID manual it will take me to the picture of the ship I have identified. That procedure does not seem to work when I am in a US sub in the PTO, and there are way too many ships to try to figure out which one I am observing. By the time I scan the target manual and select my target, it has sailed off. This applies to merchants particualary. Any ideas on this one? The manual does not seem to open automatically when using the button to try to ID the target. Nor do I see the ID of the target at the bottom of the screen.