[REL] Trevally - Harbour Pilot Scripts

[Trevally.]

See post 1 for new version 2.1

This was due to a bad coordinate in both Canal nav files.

I had intended to run the boat close to shore after exit of canal as a joke

My error was that this might be funny first time, but not every time.
If boat is at extreme speed it may be too close.
I also repeated the coordinate in the inbound nav file - I did not intend to do this.

V2.1 removes this bad coordinate from both.

Sorry everyone

[DavyJonesFootlocker]

OK I'll try again.

[Trevally.]

Hi Davy,

V2.1 is working well.

There is a small problem with them reacting with UI 4.5.0.
This results in 2 scripts being missing :-

KielCanalInbound
Lorient

I will get back to you with how to fix shortly.

Edit - Until the next TDW UI version, everyone using harbour pilot will need to unistall UI v4.5.0 and Harbour pilot v2.1

Delete the following files from NewUIs_TDC_4_5_0_ByTheDarkWraith:-

NewUIs_TDC_4_5_0_ByTheDarkWraith\data\Navigation\K ielCanalOutbound.shn
NewUIs_TDC_4_5_0_ByTheDarkWraith\data\Automation\K iel.sha

Reinstall UI then Harbour Pilot using JSGME

[DavyJonesFootlocker]

Thanks.

[Trevally.]

***WARNING***

St Nazaire is not working - do not use. (will be fixed in v2.2)

[Trevally.]

I have been fixing and testing St Nazaire and I have finally found the correct method for achieving accurate turning arcs for non-precision

Now I can rewrite the tight harbours using this with reduced heading call outs

[TheDarkWraith]

Originally Posted by Trevally.

I have been fixing and testing St Nazaire and I have finally found the correct method for achieving accurate turning arcs for non-precision

Now I can rewrite the tight harbours using this with reduced heading call outs

so non-precision navigation is working well and I don't need to spend anymore time on it?