A GWX U-Boat Skins Question.

[Kafka BC]

Originally Posted by HW3

I am not certain but, I believe the skins for GWX were made by Fubar, and had been already released by him for all to use. Jimbuna would know if that is correct or not.

I suspected that they might be, and if that is so, than I will use them...I would like know for sure. However, the files that I download from Jimbuna's list contain 2048 x 2048 textures that are 12 meg in size while the ones in the .dat files are 1024 x 1024 and only 3 meg in size.

I was really hoping that I could download the smaller textures somewhere so that I wouldn't have to install GWX and extract them from the files.

Kafka BC

[Jimbuna]

I think you are after the low resolution skins....there are some on my FF account IIRC.

[Kafka BC]

Originally Posted by jimbuna

I think you are after the low resolution skins....there are some on my FF account IIRC.

Thank You Jim, I will go check them out. So the one's in GWX are Fubar's then?

If and when I finish this Mod, there may be something in it that you GWX guys might want. I have managed to change the look of the foam as it flows past the subs to something that, I think, looks a little more realistic.

Regards
- Kafka BC

The Fubar skins were adopted for GWX and adapted as needed.
(That's direct from the Manual, page 116)

[Kafka BC]

Originally Posted by privateer

The Fubar skins were adopted for GWX and adapted as needed.
(That's direct from the Manual, page 116)

Whoops, missed that. Missed the one on page 533 too. But then again I found it a hard read. Acrobat Reader + Big PDF files = No Pleasure.