Automation

[Krauter]

I just blended (well copied and pasted) my files into yours, and now the automation works completely fine. Except for one thing. Everything is rushed.

For example with my scripts of pre-surface action:


[AS]
Miscellaneous
[CATEGORY]
Pre-Surface Actions
[COMMANDS]
Ahead_one_third,0,0,0,0,0,0,5 ; ahead 1/3 bell
Report_nearest_sound_contact,0,0,0,0,0,0,1 ; report the nearest sound contact detected.
Double_knuckle_port,0,0,0,0,0,0,5 ; 90 degree turn to port followed by a short straight run followed by another 90 degree turn to port
Double_knuckle_port,0,0,0,0,0,0,15 ; 90 degree turn to port followed by a short straight run followed by another 90 degree turn to port
Double_knuckle_starboard,0,0,0,0,0,0,5 ; 90 degree turn to starboard followed by a short straight run followed by another 90 degree turn to starboard
Double_knuckle_starboard,0,0,0,0,0,0,0.5 ; 90 degree turn to starboard followed by a short straight run followed by another 90 degree turn to starboard
Hydrophone_normal_sweep,0,0,0,0,0,0,2 ; perform normal sweeps on hydrophone
Periscope_depth,0,0,0,0,0,0,1 ; go to periscope depth.
Rise_whole_obs_periscope,0,0,0,0,0,0,0.5 ; fully raise the obs scope
Activate_Scope_Station,1,0,0,0,0,0,0.5 ; activates a scope station where x = the scope station number (0=attack, 1=obs, 2=UZO)
Sweep_Scope,1,0,360,30,0,0,0.5 ; sweep the scope from a start of y degrees to an end of z degrees
Leave_Scope_Station,0,0,0,0,0,0,2 ; leaves the scope station and returns to bridge
Surface,0,0,0,0,0,0,1 ; surface the boat ;
Ahead_standard,0,0,0,0,0,0,1 ; ahead standard bell
[COMMANDS_END]

Everything is rushed, My double Knuckles are commanded one after the other, not 5 seconds after the command had been EXECUTED (not uttered) like I thought. Same with the Periscope sweep. Order Periscope depth, immediately gone to Obs Periscope and then I've completed the sweet way before the scope has even broken the surface..