Relearning SHIII Need Help Bad

smilinicon · 06-27-10, 10:08 AM

with the target locked, you run the speed timer (low left hand of notepad). Run it for at least 6 seconds and then click it again to get the speed. Note it reads how much the scope moves in degrees to get the speed, so if you are moving it throws off the reading. You also have to have a good range and AoB reading beforehand. I double click the checkmark before launching to get the gyro set correctly. I would suggest using the notepad or the manual entry (either or but don't mix the two).

06-27-10, 10:08 AM	#2
smilinicon Bosun Join Date: Apr 2005 Posts: 66 Downloads: 69 Uploads: 0	with the target locked, you run the speed timer (low left hand of notepad). Run it for at least 6 seconds and then click it again to get the speed. Note it reads how much the scope moves in degrees to get the speed, so if you are moving it throws off the reading. You also have to have a good range and AoB reading beforehand. I double click the checkmark before launching to get the gyro set correctly. I would suggest using the notepad or the manual entry (either or but don't mix the two).