![]() |
SUBSIM: The Web's #1 resource for all submarine & naval simulations since 1997 |
|
![]() |
#1 |
Ace of the Deep
![]() |
![]()
...and don't forget to open your tube doors before firing. I make that mistake a bit.
![]()
__________________
![]() ![]() ![]() |
![]() |
![]() |
![]() |
#2 |
Samurai Navy
![]() Join Date: Mar 2010
Location: somewhere in the Past.
Posts: 582
Downloads: 541
Uploads: 0
|
![]()
there's an S-boat in that lil pic. sometimes when you fire torpedos at one target and then swich to the next the tdc will keep the bearing of the last thing you shot at and you'll have to hit the red button on the parascope or your torpedos will go sailing off in an unwanted direction.
__________________
"Diesel Pig" Not so long ago... |
![]() |
![]() |
![]() |
#3 |
Navy Seal
![]() |
![]()
I took him to mean his attack map showed the torpedo path intersecting with his chosen target. If that's so, then torpedo malfunction is the most likely cause. The attack map will show if you have left previous settings active.
I missed that reference to the stern tubes! Hey, you have air conditioning now. How could you miss THAT? ![]()
__________________
Sub Skipper's Bag of Tricks, Slightly Subnuclear Mk 14 & Cutie, Slightly Subnuclear Deck Gun, EZPlot 2.0, TMOPlot, TMOKeys, SH4CMS |
![]() |
![]() |
![]() |
#4 |
Ocean Warrior
![]() Join Date: Sep 2008
Location: Notify command we have entered the Grass Sea
Posts: 2,822
Downloads: 813
Uploads: 0
|
![]()
I had reset the TDC, as the "X" intersected my boat.
|
![]() |
![]() |
![]() |
#5 |
Samurai Navy
![]() Join Date: Mar 2010
Location: somewhere in the Past.
Posts: 582
Downloads: 541
Uploads: 0
|
![]() ![]() ![]() ![]() ![]()
__________________
"Diesel Pig" Not so long ago... |
![]() |
![]() |
![]() |
#6 |
Ocean Warrior
![]() Join Date: Sep 2008
Location: Notify command we have entered the Grass Sea
Posts: 2,822
Downloads: 813
Uploads: 0
|
![]()
I meant to say the "X" intersected the target. Rockin Robbins is probably correct. The TDC was not working correctly. On the aft shots, I may have missed because my boat was turning and the TDC was not working correctly.
p.s. I miss the captains who sailed of the SH5. And where is Ducimus? |
![]() |
![]() |
![]() |
#7 |
XO
![]() Join Date: Jul 2002
Location: Florida
Posts: 400
Downloads: 126
Uploads: 0
|
![]()
As was stated above any new target bearing must be re-entered into the TDC. This can only be done by setting the range again. One of the SH4 annoyances. If you indeed have a proper solution and turn on tracking (red light) it should do this automatically. I think. I never turn on tracking because I hadn't had luck with it. A weakness on my part.
Did you turn on tracking? If not shooting at multiple target bearings get to be complex. Especially if you sub is moving. You have to re-figure AOB in a matter of seconds. |
![]() |
![]() |
![]() |
#8 |
XO
![]() Join Date: Jul 2002
Location: Florida
Posts: 400
Downloads: 126
Uploads: 0
|
![]()
As was stated already any new target bearing must be re-entered into the TDC. This can only be done by setting the range again. One of the SH4 annoyances. If you indeed have a proper solution and turn on tracking (red light) it should do this automatically. I think. I never turn on tracking because I hadn't had luck with it. A weakness on my part.
Did you turn on tracking? If not shooting at multiple target bearings get to be complex. Especially if you sub is moving. You have to re-figure AOB in a matter of seconds. |
![]() |
![]() |
![]() |
#9 |
Ocean Warrior
![]() Join Date: Sep 2008
Location: Notify command we have entered the Grass Sea
Posts: 2,822
Downloads: 813
Uploads: 0
|
![]()
whenever I adjust any of the Attack Dials, I always send it to the by clicking the little pointer device. That was not the problem unfortunately. It is hard for me to believe the TDC was screwed up, but whatever happened, I had not seen it before.
|
![]() |
![]() |
![]() |
|
|