GWX/sh3commander transfer problems.

bigboywooly · 02-22-10, 05:26 PM

Am guessing you have the GWX specific cfgs for SH3Commander ?
Starrting at 0 Lat/Long indicates a problem somewhere - sometimes using an old career after upgrading to GWX though that can clear itself next time out.

jiduthie · 02-22-10, 08:09 PM

yeah i have the gwx specific configs for sh3 commander. GWX was installed over a completely clean sh3 1.4 installation, as in sh3 had never been installed on this particular installation of windows and I had started no careers prior to installing GWX.

You're right though, now that I think of it. It was 0,0 most likely, hadn't noticed. But again, it only happens after I try transferring to the 23rd/29th from lorient, 2nd flotilla. If I reload the save at the end of the previous patrol I can start the next as normal or transfer to the 10th and start, oddly, in Salamis.

02-22-10, 05:26 PM	#1
bigboywooly Rear Admiral Join Date: Apr 2006 Location: Swindon, England Posts: 10,151 Downloads: 35 Uploads: 0	Am guessing you have the GWX specific cfgs for SH3Commander ? Starrting at 0 Lat/Long indicates a problem somewhere - sometimes using an old career after upgrading to GWX though that can clear itself next time out. __________________ My mediafire page http://www.mediafire.com/?11eoq19bq9r41

02-22-10, 08:09 PM	#2
jiduthie Swabbie Join Date: Jun 2007 Posts: 13 Downloads: 17 Uploads: 0	yeah i have the gwx specific configs for sh3 commander. GWX was installed over a completely clean sh3 1.4 installation, as in sh3 had never been installed on this particular installation of windows and I had started no careers prior to installing GWX. You're right though, now that I think of it. It was 0,0 most likely, hadn't noticed. But again, it only happens after I try transferring to the 23rd/29th from lorient, 2nd flotilla. If I reload the save at the end of the previous patrol I can start the next as normal or transfer to the 10th and start, oddly, in Salamis.