SH3 Commander R2.6 NOW AVAILABLE!

It762 · 12-22-09, 04:40 PM

Thanks for your response.
Probably I didn't see it there andyes maybe the other thread would be better.

I reinstalled now all again from admin rights and on a clean folder the gwx installation succeeded without an error the 2nd time. So somewhere I must have done something unexpected before.

Now I have installed SH3 commander (the latest version, I had it before too), but I did not try it out yet. And I am not sure if I should

One question:
In stock sh3 when I start the "diesel" engines (1/3 ahead etc) I hear them clearly. When GWX is installed I hear them only in the "outside" view. As I said I did not tinker with the TC settings this time and the previous "SH3 own document files" were deleted.

I will check also the SH3 cmdr. thread for infos

Thanks again!

12-22-09, 04:40 PM	#11
It762 Gunner Join Date: May 2005 Posts: 97 Downloads: 3 Uploads: 0	Thanks for your response. Probably I didn't see it there andyes maybe the other thread would be better. I reinstalled now all again from admin rights and on a clean folder the gwx installation succeeded without an error the 2nd time. So somewhere I must have done something unexpected before. Now I have installed SH3 commander (the latest version, I had it before too), but I did not try it out yet. And I am not sure if I should One question: In stock sh3 when I start the "diesel" engines (1/3 ahead etc) I hear them clearly. When GWX is installed I hear them only in the "outside" view. As I said I did not tinker with the TC settings this time and the previous "SH3 own document files" were deleted. I will check also the SH3 cmdr. thread for infos Thanks again!