Mapping Hydrophone volume to keyboard ?

[runio]

Originally Posted by Fubar2Niner

My guess is this is the correct route, but I have no idea about key codes etc. If anyone could help an old lag, I'd be most grateful

Just look here:
http://www.cambiaresearch.com/articl...odes-key-codes
You need to change these decimal values to hex.
So, to assign the shift-h key, you need to write:

Key0=0x48,s,"Shift+H"

Because:
the 'H' key is 72 dec = 48 hex
's' - action with the 'shift' key ('c' for the 'control' key).
Good luck.

[Fubar2Niner]

Originally Posted by runio

Just look here:
http://www.cambiaresearch.com/articl...odes-key-codes
You need to change these decimal values to hex.
So, to assign the shift-h key, you need to write:

Key0=0x48,s,"Shift+H"

Because:
the 'H' key is 72 dec = 48 hex
's' - action with the 'shift' key ('c' for the 'control' key).
Good luck.

Thanks for the info runio, will this make the example key a simple toggle ie. increase/decrease volume?

Best regards.

Fubar2Niner

[runio]

Originally Posted by Fubar2Niner

Thanks for the info runio, will this make the example key a simple toggle ie. increase/decrease volume?

I don't know, you have to check it yourself.

Greetings

[Fubar2Niner]

@runio

Hi shipmate, work has been a royal pita, so I didn't get chance to try out the keymap. Finished work early today so took the plunge...... It works !!!!! Thanks for your help mate, the phones volume is so much easier to use now. Thanks a bunch kaleun

Best regards.

Fubar2Niner