![]() |
Mapping Hydrophone volume to keyboard ?
Hi shipmates.
Like the question says, I want to map my h/phone volume control to my k/b but have no idea how to do it. I've looked in commands_en.cfg, which I guess is the right route to go, and have found....... [cmd146] Name=Change_hydrophone_volume Ctxt=1 My guess is this is the correct route, but I have no idea about key codes etc. If anyone could help an old lag, I'd be most grateful :arrgh!: Best regards. Fubar2Niner |
Quote:
http://www.cambiaresearch.com/articl...odes-key-codes You need to change these decimal values to hex. So, to assign the shift-h key, you need to write: Code:
Key0=0x48,s,"Shift+H" the 'H' key is 72 dec = 48 hex 's' - action with the 'shift' key ('c' for the 'control' key). Good luck. |
Quote:
Thanks for the info runio, will this make the example key a simple toggle ie. increase/decrease volume? Best regards. Fubar2Niner |
Quote:
Greetings |
Update
@runio
Hi shipmate, work has been a royal pita, so I didn't get chance to try out the keymap. Finished work early today so took the plunge...... It works !!!!! :yeah: Thanks for your help mate, the phones volume is so much easier to use now. Thanks a bunch kaleun :salute: Best regards. Fubar2Niner |
All times are GMT -5. The time now is 07:58 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1995- 2025 Subsim®
"Subsim" is a registered trademark, all rights reserved.