SUBSIM Radio Room Forums



SUBSIM: The Web's #1 resource for all submarine & naval simulations since 1997

Go Back   SUBSIM Radio Room Forums > Silent Hunter 3 - 4 - 5 > Silent Hunter III
Forget password? Reset here

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 03-12-08, 07:32 PM   #1
ddiplock
Samurai Navy
 
Join Date: Jul 2002
Location: Scotland, UK
Posts: 552
Downloads: 31
Uploads: 0
Default Does GWX2 simulate the concept of a Uboat's "trim"?

Ok. so U94 was approching a large convoy but was detected by the escorts, my fault for trying to take the boat in on the surface at midnight when it wasn't pitch black, it still looked like daytime infact but i was hoping the fog would mask my appraoch, never mind.

Anyway, when I was diving down, my boat appeared to be "rear end" heavy, I had no flooding damage or excess water in the boat, but my CE could not maintain the boat at the depth I required. I had the boat sink down to 240mtrs (yes, the hull held together to my amazment ) before i increased engine speed to gain some control of the boat.

That was the only way I my CE was able to hold the boat then when I ordered us upto 200mtrs. If I ran the engines at slow, to 2knts, the rear of the boat seemed to pull us back down.

My only theory is that the trim on my boat was screwed up which is my I couldn't keep her level without a proper 5 knots or so.

Anyone know about this?
ddiplock is offline   Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:58 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1995- 2025 Subsim®
"Subsim" is a registered trademark, all rights reserved.