Mod soup - help requested

bert8for3 · 09-19-11, 06:55 PM

I could use some help. I think I've hit the wall all of a sudden on figuring out mod compatibility and sequence. Not that I necessarily had it right before, but at least things worked. Now I'm getting a whole lot of "conflict" messages, and I'm just not sure what's ok and what's not.

Fig 1 is my previous mod list. As I say it's entirely possible that some things were wrong, but it did work. You can see I was using TDW's ver 660 and OHII ver 1.2 .

Fig 2 shows enabled mods up to TDW's 680. I'd enabled 680 fine, but after that and pretty much following the installed mod sequence from Fig 1, but substituting OHII ver 1.3, I started to get a whole lot of conflict messages.

Any chance someone could take a look at the sequence of mods from Fig 1 that I would install after TDW's 680 (and substituting OHII 1.3) and point me in the right direction?

Thanks much.

09-19-11, 06:55 PM	#1
bert8for3 Ace of the Deep Join Date: Dec 2005 Location: Canada Posts: 1,124 Downloads: 110 Uploads: 0	Mod soup - help requested I could use some help. I think I've hit the wall all of a sudden on figuring out mod compatibility and sequence. Not that I necessarily had it right before, but at least things worked. Now I'm getting a whole lot of "conflict" messages, and I'm just not sure what's ok and what's not. Fig 1 is my previous mod list. As I say it's entirely possible that some things were wrong, but it did work. You can see I was using TDW's ver 660 and OHII ver 1.2 . Fig 2 shows enabled mods up to TDW's 680. I'd enabled 680 fine, but after that and pretty much following the installed mod sequence from Fig 1, but substituting OHII ver 1.3, I started to get a whole lot of conflict messages. Any chance someone could take a look at the sequence of mods from Fig 1 that I would install after TDW's 680 (and substituting OHII 1.3) and point me in the right direction? Thanks much. __________________