SUBSIM Radio Room Forums



SUBSIM: The Web's #1 resource for all submarine & naval simulations since 1997

Go Back   SUBSIM Radio Room Forums > Silent Hunter 3 - 4 - 5 > SHIII Mods Workshop
Forget password? Reset here

Reply
 
Thread Tools Display Modes
Old 04-10-10, 10:02 AM   #1
Akula
Electrician's Mate
 
Join Date: Jan 2002
Location: Dublin, Ireland
Posts: 137
Downloads: 56
Uploads: 0
Default Is there a mod that tones down destroyer effectiveness

I am using GWX 3 and was if there is a mod that can town down the destroyer effectivness a bit...

My periscope gets detected from myles away (that due to radar?)

I am in the middle of a convoy and en early war escort is giving me a terrible time by knowing exactly what I am doing and where I am..

I am not sure if I am just not borne to be a Uboat skipper but seriously.

So, is there a mod that is compatible with GWX3 that can town down destroyers visual and detection capabilities, and that of Merchants?

Thanks,
G
Akula is offline   Reply With Quote
Old 04-10-10, 12:40 PM   #2
KL-alfman
Grey Wolf
 
Join Date: Nov 2009
Location: Weimar
Posts: 930
Downloads: 86
Uploads: 0
Default

could it be that your tower was revealed due to heavy sea?
or what depth do you sail when attacking submerged?

you were silent running, I suppose?
__________________
Life, Liberty and Property!
KL-alfman is offline   Reply With Quote
Old 04-10-10, 12:43 PM   #3
comet61
Sparky
 
Join Date: Oct 2009
Posts: 151
Downloads: 240
Uploads: 0
Default Being sneaky

First off....keep your periscope under the surface as much as possible. If you are going as fast as 1/3 or faster, they can spot a periscope wake from a good distance (they have good watchouts). Usually, if I am creeping up on a convoy, I go "silent running" mode and if I need to go up-periscope for a quick visual I try not to go faster than 3 knots. If the wind is 4m/s or less, it is easy for the enemy to spot your scope if you leave it up too long. Usually, if I need a firing solution calculation, I'll come to a full stop and put the scope just above the surface, get a rough AoB calc, then down scope. Wait....then repeat the process for AoB correction and distance. Calculating speed can be tricky if you have the map contacts off, but it can be done.

In rougher weather, I usually don't bother too much with calculations. If the wind is blowing at 8m/s or more, the top of your conning tower could get exposed in the swells...which makes you pretty visible. I just get as close as possible and fire all 4 tubes at 3-8° spread, set for impact then dive deep as possible. Sometimes the "spray and pray" method can yield some interesting results....
comet61 is offline   Reply With Quote
Old 04-11-10, 11:24 AM   #4
STEED
Lucky Jack
 
Join Date: Jan 2006
Location: Down Town UK
Posts: 27,695
Downloads: 89
Uploads: 48


Default

Find the convoy, get in front of the convoy, dive, all stop, silent mode, wait. Your ears are your eyes and only take a peek now and again. Select a nice juicy one or two then give them a good hammering.
__________________
Dr Who rest in peace 1963-2017.

To borrow Davros saying...I NAME YOU CHIBNALL THE DESTROYER OF DR WHO YOU KILLED IT!
STEED is offline   Reply With Quote
Old 04-11-10, 12:53 PM   #5
Jimbuna
Chief of the Boat
 
Jimbuna's Avatar
 
Join Date: Feb 2006
Location: 250 metres below the surface
Posts: 190,615
Downloads: 63
Uploads: 13


Default

The most effective method I've ever found to tone down a destroyers effectiveness is to hit it with a G7e/T2 torpedo

On a serious note though, I'm not aware of anything other than trying an alternative supermod.

Without naming names I do believe some of the destroyers characteristics are not as sharp on one or two other alternatives.

Try them all and decide what suits you best.
__________________
Wise men speak because they have something to say; Fools because they have to say something.
Oh my God, not again!!

Jimbuna is offline   Reply With Quote
Old 04-11-10, 01:51 PM   #6
STEED
Lucky Jack
 
Join Date: Jan 2006
Location: Down Town UK
Posts: 27,695
Downloads: 89
Uploads: 48


Default

I seem to recall you could make the escourts less smart but it takes time to do it, that was 2 or more years ago.

I found one of my old threads it may help.
http://www.subsim.com/radioroom/showthread.php?t=113757
__________________
Dr Who rest in peace 1963-2017.

To borrow Davros saying...I NAME YOU CHIBNALL THE DESTROYER OF DR WHO YOU KILLED IT!

Last edited by STEED; 04-11-10 at 02:04 PM.
STEED is offline   Reply With Quote
Old 04-11-10, 04:51 PM   #7
brett25
Seasoned Skipper
 
Join Date: Mar 2008
Location: Oakland CA, USA
Posts: 737
Downloads: 570
Uploads: 0
Default

also your screws are a big factor in being detected- anything over 3 knots and they will hear you for sure. Remember they have hydrophones too! Try to keep your submerged speed to 2 knots, 3 knots if you must

however, if you still wish to edit the game files, you must edit the sim.cfg file located in CFG folder. Im not sure what settings, its pretty complicated.

Last edited by brett25; 04-13-10 at 01:06 PM.
brett25 is offline   Reply With Quote
Old 04-13-10, 08:49 AM   #8
Drifter
Frogman
 
Join Date: Mar 2010
Posts: 308
Downloads: 75
Uploads: 0
Default

Gian, you might want to check out this older thread:

http://www.subsim.com/radioroom/showthread.php?t=121900


CB's AI enhancement mod (supposedly easier than GWX ai):

http://www.ebort2.co.uk/files/AIFight2.zip
__________________

Drifter is offline   Reply With Quote
Old 04-13-10, 11:18 AM   #9
Akula
Electrician's Mate
 
Join Date: Jan 2002
Location: Dublin, Ireland
Posts: 137
Downloads: 56
Uploads: 0
Default

Thanks for all the hints, tips and help fellow captains...

I will first try different tactics...if I find myself failing as as a kaluen I might try modding or changing but first practice a bit with different tactics first as mentioned here.

Thanks again!
Akula is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:42 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1995- 2025 Subsim®
"Subsim" is a registered trademark, all rights reserved.