If you import the entire dat-file of a conning tower, you will be able to see it as well. Make sure to add it all the way at the end at the file (select the last node, usually Eof) so it doesn't mix with the original nodes/chunks. Start moving the root node of the tower to where you want it to sit, and then once done, copy those translation/rotation values to the dummy node of the tower on the submarine hull. Finally, remove the tower again (all chunks, not just the node, also the materials and the other extra chunks), and voila... Alternatively, you could copy the translation/rotation values after you have them to notepad, close the file without saving and reopen the sub file and then change the values.
|