SUBSIM: The Web's #1 resource for all submarine & naval simulations since 1997 |
01-27-22, 01:25 PM | #1 |
Planesman
Join Date: Mar 2008
Location: Gdańsk,Poland
Posts: 197
Downloads: 202
Uploads: 0
|
Crew don't show up on brige
after surfacing, how do i fix this?
thx for your work |
01-27-22, 02:18 PM | #2 |
CTD - it's not just a job
|
You don't mention any details. It has been a while since I used KSD, but did you use the crew elsewhere in the boat? Are they at the proper "duty station" to be on the bridge? A big problem can be leaving the crew at Battle Stations too long, and they might be exhausted, and can't get themselves to climb the ladder to get topside... If you are at Battle Stations, relieve the crew of that, and dive to 35m or so, and give everybody a few hours worth of rest, then try again. One last question: if you were depth charged, are any of the crew injured or dead? You might have to drag the dead and / or injured to other locations, and then drag new crew members to watch stations.
|
01-27-22, 03:42 PM | #3 |
Planesman
Join Date: Mar 2008
Location: Gdańsk,Poland
Posts: 197
Downloads: 202
Uploads: 0
|
Yes sorry about being too vague
I was not in battle stations mode, just first time test diving 60 miles from Wilhelmshaven after surfacing boat there was only I, the captain no watch crew no watch officer, so i enter i battle station mode but they don't show anyway. In crew menagment all looking good they are on topside compartment |
01-28-22, 05:02 AM | #4 |
Sea Lord
|
I am not sure what version of KSD II you are using. But perhaps you don't see the crew because your camera is too close. At watch crew station try moving around with keyboard arrow keys to maybe get further from the crew so they would appear.
|
|
|