CCOM 12.0

[Mad Mardigan]

Just started to get this (CCoM v12) set up, and am having some.... fun... getting it finalized.

Main thing is, initial set up of SH3, I set it to open up in full screen & no problems there.

I set up the base mod, setting up the h.sie options up, before activating that. I tested it in training... & when I rang up for flank speed & checked the periscope... it did NOT go back down as it should.

So... what do I do to resolve that issue... & I have all the boxes check marked, just as I do, what with LSH3-2015 (& periscope goes down when I am going flank ahead in it...).

2nd issue have run into, is with attempting to activate the

'Ahnenerbe_WS-GUI_1920x1080_for_CCoM_by Wurmonkel'

On activating it, I checked the h.sie options & recheck marked all as before, as for some reason, it ended up being unchecked except for the '4GB patch' & 'move 1WO to Bridge'.

After activating & double checking the h.sie options, I end up getting the message of

'can not initialize 3D engine' error popping up.

Mod list is as follows:

Generic Mod Enabler - v2.6.0.157
[C:\Games\Silent-Hunter\SH3\CCoM-v12\MODS]

CCoM_CaptainsChoiceOfMods_Release_120_BASIS_EC
CCoM_CaptainsChoiceOfMods_Update_Bunker-Start_120
CCoM_CaptainsChoiceOfMods_Update_Ohne-Orden_120
Fix_Catalina_CCOM12
Ccom_New_Antenna&Guns
CCoM v12-Harder escorts from NYGM
CCoM_RadioMessages_English
O2-Gauges v2
Ccom_New_Environment
SH-5 Water for SH-3 20 Km V84
SH-5 Water for SH-3 Bigger Sun v2
Stream_BlueWater
Sober's 3D waves mod

M. M.



p.s.

Monitor I have, is a HP LV2011, with res of 16x9