SUBSIM Radio Room Forums


SUBSIM: The Web's #1 BBS for all submarine and naval simulations since 1997

Go Back   SUBSIM Radio Room Forums > Modern-Era Subsims > Dangerous Waters plus New Developments > Red Storm Rising
Forget password? Reset here

 
 
Thread Tools Display Modes
Old 09-01-2006, 08:59 PM   #1
Badger6052
Swabbie
 
Join Date: May 2006
Location: Thousand Palms, CA
Posts: 10
Downloads: 335
Uploads: 0
How do you "match" another submarines' depth?

Sept. 1 2006

A silly question I would think to those a little more experienced with Dangerous Waters/Sub Command - but I have know idea how you determine another subs depth! Could someone give me a hand!?:hmm::hmm::hmm:
__________________
Steven L. Edwards
Palm Springs, Ca.
Badger6052 is offline  
Old 09-02-2006, 06:59 AM   #2
Bill Nichols
Master of Defense
 
Join Date: Mar 2000
Posts: 1,504
Downloads: 125
Uploads: 0
Default

Best you can do is to determine if the other sub is on the same 'side' of the layer as you or not. Do this by seeing how its passive sonar signal changes when you move across the layer.
__________________
My Dangerous Waters website:
Bill Nichols is offline  
Old 01-31-2011, 09:05 PM   #3
streakeagle
Swabbie
 
Join Date: Apr 2004
Posts: 8
Downloads: 0
Uploads: 0
Default

In real submarines, you can determine the depression/elevation of the sound hitting your array. With a spherical array, the tracker automatically tracks both bearing and d/e angle. The towed array has conical beams, so the angle measured by the tracker is always a mix between vertical and horizontal components. But if you put the contact on your beam, you get his bearing, and if you put him on your bow, you get the d/e angle. Because sound bends and bounces so much in the water, the vertical angle is ignored a lot of the time, but under certain conditions, it can help you determine the range to the contact. If you knew the exact path the sound is taking and you knew the exact range to the target, you could in theory estimate the depth of the contact. However, passively derived information is seldom anywhere near accurate enough to predict target depth. In relatively shallow water with the right bottom type, the d/e angle can be used to estimate range assuming bottom bounce path with a single bounce. The inability to determine the depth of the target is not very critical except in two circumstances: close aboard contact and torpedo presets. With close aboard contacts, the bearing rate is so high that you don't care about the d/e angle, you just maneuver as best as possible to avoid a collision. Torpedoes with wire guidance can let you know where the target is if they can acquire it, but their beams are somewhat narrow, so if your best guess at the target depth is wrong, or the target changes depth, you may never find it with the seeker. Fortunately, most sub captains respond to torpedo shots with all-ahead flank, allowing passive means to be used to continue tracking the target even if the depth is wrong. The hardest targets to find and kill are those that are dead quiet, aren't moving relative to the line of sight, and are masked by surface clutter (stormy waves, heavy rain, etc.) or bottom clutter (especially bottoms that reflect active frequencies). Having the courage to come to a stop near the surface or bottom while a torpedo is coming is something few sub captains have, but there isn't a torpedo in the world that can find and hit such a target except by luck. Of course, if aircraft are around, hanging out near the surface is a death wish due to visual and MAD detection risks. In "blue water" combat with fair weather, there is no bottom or waves to mask the sub, so playing depth and course change games are about all you can do to foil an opponent that has detected you. The Baton Rouge came up with a great way to completely solve the range, depth, and classification problems encountered during cold war sub chases. Point at the contact until you hear the ring of steel hulls bouncing off each other (range 0, depth within 20 to 40 feet of yours), then go to periscope depth to classify the contact visually when he surfaces to assess the damage.
__________________
former STS1(SS) on USS Dolphin AGSS-555 1994-1997
STS2(SS) on USS Richard B Russell SSN-687 1990-1994
streakeagle is offline  
Old 03-21-2012, 10:13 AM   #4
arief.satriyo
Seaman
 
Join Date: Feb 2012
Location: Indonesia
Posts: 42
Downloads: 30
Uploads: 0
D/E angle

is there any mod out there (whether for DW or Sub Command) that modeled D/E angle..??
arief.satriyo is offline  
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:33 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Copyright © 1995- 2019 Subsim