Help ! ATI Users, specially X800 series.

[U-214]

Should be available through the display properties "advanced" button.

However if not available try using a third party set of software like Tray Tools or RIVA tuner you can find these at downloads section of http://www.guru3d.com/

Thank you for the reply.I can't find it in the advanced properties.Maybe i should have used the drivers with a Catalyst control center thing instead of control panel?

Anyway,i will try those tools.
Thank you.

[Redwine]

Originally Posted by U-214

Thank you for the reply.I can't find it in the advanced properties.Maybe i should have used the drivers with a Catalyst control center thing instead of control panel?

Anyway,i will try those tools.
Thank you.

May be... i am using the small version with Control Panel instead Control Center like you.

I have the temperature showed into divers panel

Right click on desktop > properties > configuration > Advanced options > and then go to the Override (tm) tab...

There you have temperature and core frecuency.

If not use the programs reccomended by Wolram

Or another one, not so pwerful than ATI Tray Tool, but so good enought > ATI Tool.

Best regards, Red.


I attempt today to install a new time ATI Tray Tool, but no way, SH3 crashes with it after few seconds of play, i attempt to change many settings but no way, always crashes. :hmm:

I back to ATI Tool and Riva Turner.

[U-214]

Thank you Redwine,but apparently my card not being for gamers,isn't supported.There isn't an override option at all.Also i tried the Tray Tools and in available hardware monitor the temperature is grayed out.

Thank you very much for the help though.

[Wolfram]

Originally Posted by U-214

Thank you Redwine,but apparently my card not being for gamers,isn't supported.There isn't an override option at all.Also i tried the Tray Tools and in available hardware monitor the temperature is grayed out.

Thank you very much for the help though.

Ahh I should have considered that possiblity - your card does not have a temperature probe so I am guessing even RIVA Tuner prog may not read it but the software still might be worth looking at, maybe a few tweaks it can provide you.

g/l

[Syxx_Killer]

I have the 5.10 version of ATI's Catalyst drivers. I'm using the Catalyst Control Center. Is there a way I can check the temperature on my card? It is an Abit Radeon RX700-Pro PCI-Express card.

[Redwine]

Originally Posted by Syxx_Killer

I have the 5.10 version of ATI's Catalyst drivers. I'm using the Catalyst Control Center. Is there a way I can check the temperature on my card? It is an Abit Radeon RX700-Pro PCI-Express card.

Hi Syxx Killer, look the comments for U-214, follow the same tips.

[Wolfram]

Originally Posted by Syxx_Killer

I have the 5.10 version of ATI's Catalyst drivers. I'm using the Catalyst Control Center. Is there a way I can check the temperature on my card? It is an Abit Radeon RX700-Pro PCI-Express card.

Got me here I am using AGP x800XT but would think somewhere within the CCC panel is a temp gauge - later ATi like yours have temp probes built in. Try the display properties method mention a couple posts above. Or through control panel.

Otherwise try this:

http://www.guru3d.com/index.php?page=rivatuner&menu=8

it has a lot but be careful about the functions RIVA is powerful stuff give you ability to mod the registry and hardware - may void a warranty also so check the Guru3D forums first before doing any power user stuff.

But it has a temp monitor and some other simple stuff too that is useful and safe to use.

g/l