Hex Edit 101

02-09-07, 05:52 PM

Do a block mark again at the 0A that should be at the start of our zon file now.
Following what we know so far this chunk is 28 bytes starting the count at
the 1st byte of the ID, which is the AD. Click on the AD.
Now, I don't want to count 28 bytes, and in bigger files we may need to move
1000's of bytes!
Select Address, then Jump width.
Set this to decimal, then enter 28, click OK.
Select Address again, Jump down and block mark this.
Do your copy and save just like before calling this introz.bin
Then Block delete, and save this file again.

We haven't lost anyone so far have we?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

02-09-07, 05:52 PM	#19
Madox58 Stowaway Posts: n/a Downloads: Uploads:	Do a block mark again at the 0A that should be at the start of our zon file now. Following what we know so far this chunk is 28 bytes starting the count at the 1st byte of the ID, which is the AD. Click on the AD. Now, I don't want to count 28 bytes, and in bigger files we may need to move 1000's of bytes! Select Address, then Jump width. Set this to decimal, then enter 28, click OK. Select Address again, Jump down and block mark this. Do your copy and save just like before calling this introz.bin Then Block delete, and save this file again. We haven't lost anyone so far have we?