SUBSIM Radio Room Forums



SUBSIM: The Web's #1 resource for all submarine & naval simulations since 1997

Go Back   SUBSIM Radio Room Forums > Silent Hunter 3 - 4 - 5 > Silent Hunter III
Forget password? Reset here

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 12-23-13, 12:43 PM   #12
gi_dan2987
Weps
 
Join Date: Jan 2011
Posts: 359
Downloads: 61
Uploads: 0
Default

That's hardcore man! The only way to play! The experience you want to have is decided by YOU and only you.

Ok so I (finally) started a campaign in NYGM3. Much different than GWX3 I must say, but so far I'm really liking it.

There's only one issue I have to bring up. I was tracking this merchant vessel for a good while, probably an hour or so. I spotted him when I was in a favorable position anyways, so I didn't need to track him longer than that. I took range/bearing estimates with the UZO at about 9000m off his starboard bow, and then turned to a heading parallel to track him. At the correct intervals I took my estimates with the UZO until I was satisfied and locked him in at 9 knots.

I also estimated his course to be about 015. Now with this I could spring ahead and get into an attack position. Confident about his speed and heading, and detecting no evasive maneuver, I got into position about 1500m off his course line. Not ideal, but good enough. I did all my final torp preps and setup battle stations. I took another reading through the periscope, and determined him to be on roughly the same course line 015. With that I used my formulas (which I've tested time and again, they're correct), to figure his AOB. He was properly ID'ed as a small merchant. With everything set, AOB and speed pre-factored, now all I had to do was one more range, lock it in, and shoot....and miss. There were no evasive maneuvers that I could tell. I tracked this guy for a long time and no variables changed, even up until the time I took my shot. Frustrated, I surfaced and put him under with my deck gun. Not my cleanest kill, but I still got the end result.

Now to the drawing board... What went wrong? What changed? What variables did I miss/mis-calculate? Up until I took my shot, I confirmed all my parameters and found them to be accurate. Could he have made just a slight course or speed change? Is the stadimeter broken? Anybody have any ideas?
gi_dan2987 is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:05 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1995- 2025 Subsim®
"Subsim" is a registered trademark, all rights reserved.