Dumb question......

ddiplock · 03-02-12, 02:04 PM

Quote:

Originally Posted by WernherVonTrapp

You are opening the tube doors (pressing the Q button) before aligning and firing right?

Yes, I am enough of a veteran to not make that mistake haha

WernherVonTrapp · 03-02-12, 02:26 PM

Sorry, I didn't mean to imply that you weren't a veteran.

Just make sure that you are not aiming at different points on the vessel, and then using the Offset. Lock onto the center and use the offset from that point.

ddiplock · 03-02-12, 03:06 PM

Quote:

Originally Posted by WernherVonTrapp

Sorry, I didn't mean to imply that you weren't a veteran.

Just make sure that you are not aiming at different points on the vessel, and then using the Offset. Lock onto the center and use the offset from that point.

Ok, but do you have to resend the bearing to the TDC after each shot/angle change??

WernherVonTrapp · 03-02-12, 05:32 PM

Not that I'm aware of. Hopefully you've already completed that part. You're just adjusting the offset based upon the last bearing you've set before firing. I don't use manual targeting so I may be incorrect on this. Hopefully, someone will correct me (soon) if I'm wrong.

DrBeast · 03-02-12, 08:47 PM

Quote:

Originally Posted by ddiplock

Ok, but do you have to resend the bearing to the TDC after each shot/angle change??

Nope, no need to. Just to make sure, are you using auto- or manual targeting?

03-02-12, 02:26 PM	#2
WernherVonTrapp Admiral Join Date: Jul 2009 Location: Now, alot farther from NYC. Posts: 2,228 Downloads: 105 Uploads: 0	Sorry, I didn't mean to imply that you weren't a veteran. Just make sure that you are not aiming at different points on the vessel, and then using the Offset. Lock onto the center and use the offset from that point. __________________ "The journey of a thousand miles begins with a single step." -Miyamoto Musashi ------------------------------------------------------- "What is truth?" -Pontius Pilate

03-02-12, 05:32 PM	#4
WernherVonTrapp Admiral Join Date: Jul 2009 Location: Now, alot farther from NYC. Posts: 2,228 Downloads: 105 Uploads: 0	Not that I'm aware of. Hopefully you've already completed that part. You're just adjusting the offset based upon the last bearing you've set before firing. I don't use manual targeting so I may be incorrect on this. Hopefully, someone will correct me (soon) if I'm wrong. __________________ "The journey of a thousand miles begins with a single step." -Miyamoto Musashi ------------------------------------------------------- "What is truth?" -Pontius Pilate

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode