|
|
SUBSIM: The Web's #1 resource for all submarine & naval simulations since 1997
|
SUBSIM: The Web's #1 resource for all submarine & naval simulations since 1997 |
|
|
08-05-10, 11:48 AM
|
#1 |
|
Ocean Warrior
 Join Date: Jan 2008
Location: Miami, FL
Posts: 3,052
Downloads: 36
Uploads: 0
|
Actually I don't know if the BIOS screen appears, the monitor was unplugged at the time. I remember she had problems earlier where the monitor would read: No Input, despite the computer being plugged in. I don't know if she ever got that fixed between here and there.
__________________
|
|
|
|
08-06-10, 10:44 PM
|
#2 |
|
Captain
 Join Date: Jan 2007
Location: Tennessee
Posts: 546
Downloads: 17
Uploads: 0
|
you would get a beep code even without a CPU or Ram ( ; Im thinking its the PSU. Plug an exhaust fan into one of the molex conecetors. Even if every component on the board is dead it should still run that fan if the PSU is good..... If the fan dont run or kinda sorta does then its either the PSU or maybe even the power switch.
__________________
|
|
|
|
|
08-07-10, 11:24 PM
|
#3 |
|
Ocean Warrior
Join Date: Jan 2008
Location: Miami, FL
Posts: 3,052
Downloads: 36
Uploads: 0
|
That's right there is no beep code.
I am going to look at the computer again tomorrow, and will get back with whatever I find out.
__________________
|
|
|
|
|
08-09-10, 11:42 AM
|
#4 |
|
Captain
Join Date: Jan 2007
Location: Tennessee
Posts: 546
Downloads: 17
Uploads: 0
|
Did ya manage to get a look at it?
__________________
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
