SUBSIM Radio Room Forums



SUBSIM: The Web's #1 resource for all submarine & naval simulations since 1997

Go Back   SUBSIM Radio Room Forums > Silent Hunter 3 - 4 - 5 > Silent Hunter III
Forget password? Reset here

Reply
 
Thread Tools Display Modes
Old 03-25-10, 03:35 AM   #1
Snestorm
Stowaway
 
Posts: n/a
Downloads:
Uploads:
Default

The only way I can think of to do it, without being stuck in TCx1 is:
Get a visual on the convoy.
Dive.
Follow with hydrophone until contact is lost.
(Usualy 2 Hours at TCx64 will do).
Surface.
Catch up.
Repeat as neccesary.
(It can still be quite time consuming).

Note on using Flank Speed:
This should only be used for VERY brief periods, for an emergency.
It's the equivalent of climbing in your UNGOVERNED car, and holding the throttle to the floor.
You may get away with it for a minute or two, but sooner or later after that you will eventualy hear B A N G, as your engine blows.
Full Speed is the fastest your engines are designed to run.
(The speed gained by using Flank is usualy not more than 1 Knot anyway.
And it sucks up the fuel, big time.)
A Steam Turbine powered warship can get away with this with comparrative ease, as compared tp our Diesel Powered uboats.
  Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:53 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1995- 2025 Subsim®
"Subsim" is a registered trademark, all rights reserved.