SH3 Commander: "Invalid argument to date encode"

[Nopileo]

Thank you.

Sorry for the late reply. I wanted to try a patrol in my new career, and then try to re-create what I did the last time before replying.

I've completed one patrol now, and exited the game like last time after giving the medals to the crew and upgrading the sub with the renown I got.

Then I fired up SH3 Commander, and selected 'Rollback SH3'. Then I edited the patrol_0.cfg file with some extra renown points like last time (I made a backup of the file just in case).

Then I started the game normally and verified the renown was there and everything else looked normal (I must confess I spent the renown on an Alberich).

Then I exited the game again and started SH3 Commander. Tried 'Summary' and everything else, and no error messages appeared. Started the game with SH3 Commander, and I'm now on patrol 2.

So I'm not sure what caused the previous error, but it works good now.

I remembered I did 'cheat' with dates on an earlier career (XXI) to be able to get the XXI when I wanted (this was basically a test career to try different XXI-tweaks), but I didn't get an error message on that career, and I didn't think that config files 'leaked' over to other career folders?

By the way, I've also put the subfoldes and files back into the 'flotillas' folder of SH3 Commander now. I had deleted them earlier to avoid the fatigue mod. Not sure if this is relevant.

Anyway it's good to be able to enjoy SH3, RUb and SH3 Commander without any 'interruptions' now, so I'm a happy puppy.

Thanks again for all the help.

Regards,

Nopileo