[REL] Operation Monsun Environmentally & Graphics Upgrade v300

[looney]

For sh3 there was a small tool which let you edit the keybindings. Is there a tool for SH4 also?

in the Kuib I sometimes have to press the update button twice. So I was thinking to make a keybind for it

[lurker_hlb3]

Originally Posted by looney

For sh3 there was a small tool which let you edit the keybindings. Is there a tool for SH4 also?

in the Kuib I sometimes have to press the update button twice. So I was thinking to make a keybind for it

The program is called "SetKeys" and the last version is 1.3. If you use it on SH4 Command files, be careful, there are differences in the "header section" of command.cfg and your going to have to do some hand edits to ensure it works correctly.

[karamazovnew]

Originally Posted by looney

For sh3 there was a small tool which let you edit the keybindings. Is there a tool for SH4 also?

in the Kuib I sometimes have to press the update button twice. So I was thinking to make a keybind for it

If you're talking about the TDC autoupdate "button" I advice against using key binds. It's not a button, it's a dial. With any dial, if you click in the exact center, it will not change. So press a bit to the side.
However, if you're keen on using a keybind, make sure to give the same keybind to the "radar_toggle_sweep_focus" command. Otherwise, the Autoupdate will toggle ON/OFF but the bulb will stay the same.

[lurker_hlb3]

OMEGU v300 Patch 3 pkg is up, see first post for download link

---------------------
All Patches are roll-ups

Install in port
---------------------


OMEGU v300 Patch 1

Added KiUB 1.1 by Karamazovnew Removed to TDC on/off from the Periscope Command Icons Command Icons
Upgraded the OM_SH3_Command_Keys to support KiUB 1.1 and set the “Torpedo Page” to the “I” key

Special note: AOBF 16-9 Res mod is no longer required and should be removed

-------------------

OMEGU v300 Patch 2

Added KiUB 1.2 Patch

Adjusted mast height for ships to equal tallest mast, the exception is the HMS Furious which uses the flight deck.

Change FOV for binoculars to 72 degrees and zoom level is set to 10.

---------------------

OMEGU v300 Patch 3

Added CrewMember3D.upc to the US side to ensure that USN crew doesn't speak german

Added some new revised German Speech files


Patch 3 changes provided by Captain von Keldunk

[Dieselglock]

Not sure if this is a problem or not but when I unzip patch 3 it says patch 2. I have downloaded and unzipped twice with the same result.

Thx

[lurker_hlb3]

Originally Posted by Dieselglock

Not sure if this is a problem or not but when I unzip patch 3 it says patch 2. I have downloaded and unzipped twice with the same result.

Thx

Well just call me "Dr. Fat Fingers". Forget to change the name. It is really Patch 3. Sorry about that.

[Dieselglock]

No problem. I figured it was something like that.

Thanks Again

[Dieselglock]

Hello Lurker,

I have another issue. I keep getting a CTD. When I got the first one I figured it was maybe something on my end. I completely removed and re installed SH4. I have also re downloaded and unzipped the mods but the problem still occurs. I start a career in the 2nd Flotilla type IX in the earliest date in 39. I run the first patrol no problem. When I return to base around Sept 22nd I dish out medals and rank advancements load torpedoes. I then leave base, ends up being October 28 I believe. Everything works fine till I save the game again. When I try to open the save or the entering or leaving base save, the game CTD's. It does not seem to matter when I save either, can be one game day or 4 game day's etc.

Thanks in advance.