VIIC/41 or VIIC/42?

Carcassonne · 08-01-05, 10:27 AM

You're on the money about them being the same.

You can always go into the config specs after purchasing one of the upgrades from the VIIC. That is, if you purchase a VIIC/42, go to uboat.net and find the correct max depth and change the .cfg to match it. I will say that the VIIC/42 does have to more torps eternally than the VIIC....I know that from personal experience.

Edit: I did forget to mention that there is a mod out there that will allow you to change the max depths for various boats...it's a mod that is brought up in a window if I'm not mistaken.

In a reply to one of my posts Duncan Idaho listed this link:

http://www.delraydepot.com/tt/sh3.htm

And I quote Duncan, "Oh, and btw, I think the number in the cfg file is actually the max depth it'll let your sub go, regardless of what you set for crush depth. So if you want a sub to go lower than that 300m, you need to use the crush depth tool to set the crush depth, then also edit that cfg file to allow you to go deeper than 300m. (I just set mine to max, which is 500, in the .cfg file)."

Hope this helps.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

08-01-05, 10:27 AM	#1
Carcassonne Loader Join Date: May 2005 Posts: 82 Downloads: 0 Uploads: 0	You're on the money about them being the same. You can always go into the config specs after purchasing one of the upgrades from the VIIC. That is, if you purchase a VIIC/42, go to uboat.net and find the correct max depth and change the .cfg to match it. I will say that the VIIC/42 does have to more torps eternally than the VIIC....I know that from personal experience. Edit: I did forget to mention that there is a mod out there that will allow you to change the max depths for various boats...it's a mod that is brought up in a window if I'm not mistaken. In a reply to one of my posts Duncan Idaho listed this link: http://www.delraydepot.com/tt/sh3.htm And I quote Duncan, "Oh, and btw, I think the number in the cfg file is actually the max depth it'll let your sub go, regardless of what you set for crush depth. So if you want a sub to go lower than that 300m, you need to use the crush depth tool to set the crush depth, then also edit that cfg file to allow you to go deeper than 300m. (I just set mine to max, which is 500, in the .cfg file)." Hope this helps.