Capt Posn on conning tower

[Mr.Fleck]

Originally Posted by DivingDuck

Moin,

here it is:



Open the Turm.cam you want to edit with any hex editor and change the highlighted values.

• x moves left - right
• y moves up - down
• z moves forward - aft

The values have to be in float(32) format.

Regards,
DD

Hello Diving Duck,

thank you for sharing your knowledge. But I think the position in the cam file is wrong. If I change the values starting from 168 (Hex position) it works!

So, in my opinion x values start at 168, y values start at 16C and z values at 170

But thank you anyway , because if you did not point us to the correct file and the approximate position I would never have found it.

Regards
Mr. Fleck