GWX 3.0, plus other mods, running problems

overlord0108 · 06-20-11, 03:53 PM

Right, so it was working perfectly fine, with GWX and SH3 Commander.

I installed all the mods and it ran perfectly for a patrol, I sank 17,000 tons of shipping, saved and then exited the patrol. Went to my next patrol where it began to load up before it had another CTD, this time not even reaching the NOT SO LONG AGO screen.

I've used BCDedit to make Vista run with 3GB of memory and I've also tried running it without the integrated orders and open hatch mod being enabled, as suggested, but it still has a CTD.

If there is anything else that I could try it would be greatly appreciated, in the meanwhile I'm going to check my mods one by one as Jimbuna has suggested.

Thanks in advance guys.

06-20-11, 03:53 PM	#9
overlord0108 Swabbie Join Date: Jun 2011 Location: Lincolnshire UK Posts: 14 Downloads: 50 Uploads: 0	Right, so it was working perfectly fine, with GWX and SH3 Commander. I installed all the mods and it ran perfectly for a patrol, I sank 17,000 tons of shipping, saved and then exited the patrol. Went to my next patrol where it began to load up before it had another CTD, this time not even reaching the NOT SO LONG AGO screen. I've used BCDedit to make Vista run with 3GB of memory and I've also tried running it without the integrated orders and open hatch mod being enabled, as suggested, but it still has a CTD. If there is anything else that I could try it would be greatly appreciated, in the meanwhile I'm going to check my mods one by one as Jimbuna has suggested. Thanks in advance guys.