![]() |
SUBSIM: The Web's #1 resource for all submarine & naval simulations since 1997 |
![]() |
#1 |
Mate
![]() Join Date: Jul 2007
Location: sweden...not switzerland - SWEDEN :)
Posts: 58
Downloads: 164
Uploads: 0
|
![]()
Dumb question.....but:
Do I need to make any corrections to the targets AOB if I usong the stern tubes? For example, my course is 000, the targets' bearing is 045R with a AOB of 045. A nice setup for my forward tubes...But if I were facing 180 degrees the bearing would change to 225R. How would this affect AOB? Am I just confusing myself? Thank you. |
![]() |
![]() |
![]() |
#2 |
Sea Lord
![]() |
![]()
I'm no expert, but I don't think AOB should be affected. AOB specifies target course, so it should remain the same. TDC knows you are setting up for stern tubes when you select a stern tube, then figures everything from there.
Just to be sure, maybe do a test in a training mission. See how it all works. |
![]() |
![]() |
![]() |
#3 |
Rear Admiral
![]() |
![]()
Only you're bearing has changed, not his course which would effect AOB.
|
![]() |
![]() |
![]() |
#4 |
Mate
![]() Join Date: Jul 2007
Location: sweden...not switzerland - SWEDEN :)
Posts: 58
Downloads: 164
Uploads: 0
|
![]()
Thanks.
|
![]() |
![]() |
![]() |
|
|