SUBSIM: The Web's #1 resource for all submarine & naval simulations since 1997 |
|
02-19-21, 05:28 PM | #1 |
A-ganger
Join Date: Jan 2021
Location: Texas
Posts: 74
Downloads: 285
Uploads: 0
|
Confused as hell
No idea what I'm doing wrong but these mods ive tried using arent working.
Ive installed them all to JSGME perfectly fine but they change nothing Is it because I'm using LSH3? |
02-19-21, 05:48 PM | #2 |
Village Idiot
|
The Devil is in the details and you have posted no details.
|
02-19-21, 05:58 PM | #3 | |
Sea Lord
|
Quote:
https://www.edilivre.com/lexpression...s-les-details/ |
|
02-20-21, 09:36 AM | #4 |
Sea Lord
|
how do you get help if you give us no details like Jeff told you ...! contact me if you want help..
|
02-20-21, 12:33 PM | #5 |
Grey Wolf
Join Date: Sep 2011
Posts: 955
Downloads: 247
Uploads: 0
|
A simple list of mods enable by JSGME would be a good start.
|
02-20-21, 12:49 PM | #6 |
Admiral
|
Re: SH3 not working as intended with mods...
Am gonna go out on a limb here.. & say, it is likely due to:
1. Being installed in either C:\Program files or C:\Program files (x86) 2. Likely without either 4GB patch applied or use of Large Address Aware, which LAA, is simpler to use in My opinion... 3. The SH3.exe in not hot listed as to have read only disabled on it... As Jeff-Groves said... the devil's in the details.. or lack there of... M. M.
__________________
|
03-14-21, 12:08 AM | #7 | |
A-ganger
Join Date: Jan 2021
Location: Texas
Posts: 74
Downloads: 285
Uploads: 0
|
Quote:
|
|
03-14-21, 04:46 AM | #8 | |
Admiral
|
Quote:
As for the rest... Applying either the 4GB patch or the Large address Aware, will assign SH3 4 Gigs of RAM. As stated, Large Address Aware, to Me, is the simplest to do. Just 3 steps & done. Step 1, browse to the SH3.exe's location in LAA. Step 2, check mark to assign it more than 2 GB's or Ram, done. Step 3., click accept or OK & done... Couldn't be any easier. So easy, a cave man could do it... Ensuring your SH3.exe is NOT read only enabled, is a simple matter of right clicking on it, selecting 'properties' from the pop up menu. In that menu box, on the main page, under the 'General' tab of that menu look for Read Only.. there is a box by it. Make sure THAT box, is NOT checked... if it is, uncheck it & then click accept. Done. While in 'Properties', go into 'Compatibility' tab... & check that 'Run as Admin', is checked. if not, then check it & click accept... Done. These steps should resolve the issues you're facing. If not, then it sounds like you may need to do a complete uninstall & reinstall as either you failed to do the taking the SH3.exe off of read only, BEFORE you ran the auto installed for LSH3 or something went wrong with LSH3 installing. Have LSH3 & am able to run it, without any issues... whatsoever. That's the only thing I can see of... Hope this info helps. M. M.
__________________
|
|
|
|