![]() |
SUBSIM: The Web's #1 resource for all submarine & naval simulations since 1997 |
![]() |
#1 |
Ace of the Deep
![]() Join Date: Jul 2002
Posts: 1,134
Downloads: 93
Uploads: 0
|
![]()
RA 1.49
I have a close approach in a sub to destroyer. I have like 2 NB harmonics on DD, but solid (no faint ghost lines). I load 5 minute earlier save, I can play through and not be detected. But if I load and save even closer, loading is instant detection; despite I can execute through that distance without detection. Why? I can think of 2 reasons: (1) The doctrine files on a load are re-initialized, therefore I might during execution slip by undetected due to where the AI is in running the detection doctrine. (2) A load results in a base noise level initially emitted which is then re-adusted for sea state, layer, flow, weather, and bottom. (If this true, then one should avoid saves when running on the edge of a razor.) Anyone else experience this? Thanks.
__________________
War games, not wars! --- Only a small few profit from war (that should not stand)! |
![]() |
![]() |
![]() |
#2 |
Bosun
![]() Join Date: Oct 2020
Posts: 69
Downloads: 25
Uploads: 0
|
![]()
I loaded several RA saves while being very close to enemies and didn´t run into immediate detection/persecution issues but most of my latest RA hours are clocked on 1.50b. Perhaps in that late save state they were already tracking you and about to ID/attack you.
Theory 2) recalls some memories but AFAIK this was long ago and only in 688HK. I remember observing scenarios where upon initializing assets left sonar traces for a short moment before going silent. |
![]() |
![]() |
![]() |
|
|